CFSound III Kit S3 
This page give a brief description of how the CFSound III Kit S3 is wired.
CFSound III Kit S3



Kit Part # Description Switch(s) Motion
Sensor(s)		 Speaker(s) CF Card
ACS-CF-CFSOUND-KITS3
Buy Online
 This kit comes with:
  (1) CFSound III with 120VAC wall transformer(view)
  (2) 1.4" Dia Black Push Buttons(view)
  (1) 5-1/4" Stereo Indoor/Outdoor black speaker(view)
  (1) 512 meg compact flash card with KITS123 sample files (view)
  (10) Feet of 22-4 gauge wire to the two push buttons(view)
  (10) Feet of 16-4 gauge wire to a single stereo speaker(view)
2
 
1
Stereo
Indoor
Outdoor
1


Indoor Outdoor AW500TT Stereo Speaker wiring
Strip one end of the 16 gauge 4 conductor wire back about four inches.
Losen the Black thumb nut, on the back of the speaker, nearest to the model number. Place the BLACK wire through the thumb nut stud, and tighten thumb nut.
Losen the Red thumb nut, on the back of the speaker, nearest to the model number. Place the RED wire through the thumb nut stud, and tighten thumb nut.
Losen the Black thumb nut, on the back of the speaker, furthest from the model number. Place the GREEN wire through the thumb nut stud, and tighten thumb nut.
Losen the Red thumb nut, on the back of the speaker, furthest from the model number. Place the WHITE wire through the thumb nut stud, and tighten thumb nut.
CFSound III Kit S3CFSound III Kit M3CFSound III Kit M3

Connect other end of 16 gauge 4 conductor wire to the CFSound III.
Red wire in CFSound III Main Connector pin #1.
Black wire in CFSound III Main Connector pin #2.
White wire in CFSound III Main Connector pin #3.
Green wire in CFSound III Main Connector pin #4.
CFSound III Kit S3

1.4" Push Button Wiring
Remove 10 - 12 inches of jacket from the 22 gauge 4 conductor wire, and strip each wire/lead back 1/4".
CFSound III Kit S3 CFSound III Kit M3

Crimp 1/4" red faston terminals on each wire.
CFSound III Kit S3

Push Button #1 - Connect the Black wire to the bottom 1/4" terminal, and the White wire to the middle 1/4" terminal.
Push Button #2 - Connect the Green wire to the bottom 1/4" terminal, and the Red wire to the middle 1/4" terminal.
CFSound III Kit S3

Remove 2 inches of jacket from the other end of the 22 gauge 4 conductor wire, and strip each wire/lead back 1/4".
CFSound III Kit S3

Connect the Black & Green wires along with the power supply ground wire to the CFSound III Main Connector in pin #10.
Connect the White wire to the CFSound III Main Connector in pin #5.
Connect the Red wire to the CFSound III Main Connector in pin #6.
CFSound III Kit S3


Return to CFSound III Page

Home
Ackerman Computer Sciences
6233 East Sawgrass Road
Sarasota, Florida 34240-8922
Phone (941)377-5775 -- Fax (941)378-4226

Copyright© 1992 - 2008 ACS, Sarasota, FL. All rights reserved. Windows TM is a trademark of the Microsoft Corporation. All other brand names or product names are or may be the trademarks or registered trademarks of their respective companies.


Last Updated 06/1/08