CFSound III Kit M3 
This page give a brief description of how the CFSound III Kit M3 is wired.
CFSound III Kit M3



Kit Part # Description Switch(s) Motion
Sensor(s)		 Speaker(s) CF Card
ACS-CF-CFSOUND-KITM3
Buy Online
 This kit comes with:
  (1) CFSound III with 120VAC wall transformer(view)
  (1) Normal Size motion sensor(view)
  (1) 5-1/4" Stereo Indoor/Outdoor black speaker(view)
  (1) 512 meg compact flash card with KITM123 sample files (view)
  (10) Feet of 22-4 gauge wire to the motion sensor(view)
  (10) Feet of 16-4 gauge wire to a single stereo speaker(view)
 
1
1
Stereo
Indoor
Outdoor
1


Indoor Outdoor AW500TT Stereo Speaker wiring
Strip one end of the 16 gauge 4 conductor wire back about four inches.
Losen the Black thumb nut, on the back of the speaker, nearest to the model number. Place the BLACK wire through the thumb nut stud, and tighten thumb nut.
Losen the Red thumb nut, on the back of the speaker, nearest to the model number. Place the RED wire through the thumb nut stud, and tighten thumb nut.
Losen the Black thumb nut, on the back of the speaker, furthest from the model number. Place the GREEN wire through the thumb nut stud, and tighten thumb nut.
Losen the Red thumb nut, on the back of the speaker, furthest from the model number. Place the WHITE wire through the thumb nut stud, and tighten thumb nut.
CFSound III Kit M3CFSound III Kit M3CFSound III Kit M3

Connect other end of 16 gauge 4 conductor wire to the CFSound III.
Red wire in CFSound III Main Connector pin #1.
Black wire in CFSound III Main Connector pin #2.
White wire in CFSound III Main Connector pin #3.
Green wire in CFSound III Main Connector pin #4.
CFSound III Kit M3

Normal Sized Motion Sensor Wiring
Remove cover from motion sensor. Use sharp object to push out plastic wiring knock out.
CFSound III Kit M3

Insert one end of 22 gauge 4 conductor wire through knock out hole.
CFSound III Kit M3

Tie a knot in the wire and pull it tight.
CFSound III Kit M3 CFSound III Kit M3

Make a note of where the black connector is snapped into place in the motion sensor.
Remove black connector from motion sensor housing.
Loosen required screws, insert each wire as shown, and tighten each screw.
CFSound III Kit M3

Snap black connector back into motion sensor housing.
Mount Motion sensor, and re-install cover.
CFSound III Kit M3

Connect other end of 22 gauge 4 conductor wire to the CFSound III.
Black and Green wires in CFSound III Main Connector pin #10, along with the black wire from the wall transformer.
Red wire in CFSound III Main Connector pin #9, along with the black with white stripe wire from the wall transformer.
White wire in CFSound III Main Connector pin #5.
CFSound III Kit M3


Return to CFSound III Page

Home
Ackerman Computer Sciences
6233 East Sawgrass Road
Sarasota, Florida 34240-8922
Phone (941)377-5775 -- Fax (941)378-4226

Copyright© 1992 - 2008 ACS, Sarasota, FL. All rights reserved. Windows TM is a trademark of the Microsoft Corporation. All other brand names or product names are or may be the trademarks or registered trademarks of their respective companies.


Last Updated 06/1/08