CFSound III Kit M2 
This page give a brief description of how the CFSound III Kit M2 is wired.
CFSound III Kit M2



Kit Part # Description Switch(s) Motion
Sensor(s)		 Speaker(s) CF Card
ACS-CF-CFSOUND-KITM2
Buy Online
 This kit comes with:
  (1) CFSound III with 120VAC wall transformer(view)
  (1) Normal Size motion sensor(view)
  (2) 4" Dual cone indoor GM65 speaker with black grill(view)
  (1) 512 meg compact flash card with KITM123 sample files (view)
  (10) Feet of 22-4 gauge wire to the motion sensor(view)
  (2)(10) Feet of 16-2 gauge wire to two speaker(view)
 
1
2
Indoor
1


Indoor GM65 Speaker wiring
Strip one end of two 16 gauge 2 conductor wires back about two inches.
Install female 1/4" crimp on faston terminals on one end of both.
Connect female 1/4" fastons to speaker terminals. Red and Black polarity should be the same on both speakers.
CFSound III Kit M3 CFSound III Kit M3 CFSound III Kit M3

Connect other end of the two 16 gauge 2 conductor wires to the CFSound III.
Left Speaker:
 Red wire in CFSound III Main Connector pin #1.
 Black wire in CFSound III Main Connector pin #2.
Right Speaker:
 Red wire in CFSound III Main Connector pin #3.
 Black wire in CFSound III Main Connector pin #4.
CFSound III Kit M2

Normal Sized Motion Sensor Wiring
Remove cover from motion sensor. Use sharp object to push out plastic wiring knock out.
CFSound III Kit M2

Insert one end of 22 gauge 4 conductor wire through knock out hole.
CFSound III Kit M3

Tie a knot in the wire and pull it tight.
CFSound III Kit M3 CFSound III Kit M3

Make a note of where the black connector is snapped into place in the motion sensor.
Remove black connector from motion sensor housing.
Loosen required screws, insert each wire as shown, and tighten each screw.
CFSound III Kit M3

Snap black connector back into motion sensor housing.
Mount Motion sensor, and re-install cover.
CFSound III Kit M3

Connect other end of 22 gauge 4 conductor wire to the CFSound III.
Black and Green wires in CFSound III Main Connector pin #10, along with the black wire from the wall transformer.
Red wire in CFSound III Main Connector pin #9, along with the black with white stripe wire from the wall transformer.
White wire in CFSound III Main Connector pin #5.
CFSound III Kit M3


Return to CFSound III Page

Home
Ackerman Computer Sciences
6233 East Sawgrass Road
Sarasota, Florida 34240-8922
Phone (941)377-5775 -- Fax (941)378-4226

Copyright© 1992 - 2008 ACS, Sarasota, FL. All rights reserved. Windows TM is a trademark of the Microsoft Corporation. All other brand names or product names are or may be the trademarks or registered trademarks of their respective companies.


Last Updated 06/1/08